MoistAir HD14070 Manuel du propriétaire télécharger pdf (Page 7)

Water Fill (continued)

Each water bottle is designed with a

"Side-Fill Cap" that is easily removable.

Remove the "Side-Fill Cap" on the side of

the water bottle by twisting

counterclockwise.

Place the opening of the water bottle

under a water faucet (the bottle should fit

under a four-inch clearance faucet). Fill

with recommended mixture of cold water

and Bacteriostat (if necessary) only. Solid

debris could make the valve leak.

Install the "Side-Fill Cap" by twisting

clockwise. Hand tighten only.

Check for possible leaks by

performing the following:

1. Grasp bottle handle and hold the bottle

upright over a sink.

2. Press up on the valve cap plunger for

about one second to let out a little

water.

Turn Counterclockwise

to Remove Cap

J

Valve Cap j

Plunger

3. Release the plunger.

4. Listen for air bubbles Look for leaks

around the "Side-Fill Cap".

5. If you hear air bubbles or see leaks,

retighten the "Side-Fill Cap" and

repeat Steps 1-4.

Wipe off excess water from the bottle.

Position the water bottle back into the

unit by grasping the water bottle handle

and lower it into the cabinet until the

bottle sits on pads at bottom of cabinet.

The "Side-Fill Cap" must be facing the

rear of the cabinet. When positioned

properly, the plunger will open and water

will flow into the cabinet. The water level

will automatically remain at approximately

1/2" until the bottles are empty.

Allow the filter to saturate for 30 minutes

before operation.

Raised

Section

Pivoting Lid Removed for Clarity

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Commentaires sur ces manuels

Pas de commentaire