13
Cleaning and Maintenance (cont’d.)
Step 2:
To Remove Parts
a. Open the pivoting lid and remove water
bottles and set aside. Grasp the fan
assembly front center and rear center.
Lift off and set aside on a clean flat
surface. The filter housings are now
accessible.
b. Before removing the internal parts of
the humidifier cabinet, we recommend
moving the humidifier to an area
where floor covers are not susceptible
to water damage, i.e.; kitchen or bath
area. Lift the filter housing assemblies
out of the cabinet and set to the side.
c. Remove the water level float from the
humidifier cabinet by pinching the float
retainer to release it from the cabinet.
The cabinet should be empty before
cleaning. The cabinet consists of the
lower areas of the humidifier where
the filters are during normal operation
time.
d. Empty cabinet of any remaining water.
e. Proceed to “Bi-Weekly Maintenance” or
“End of Season Maintenance”.
f. Remove old filters and dispose of
properly as described on pages 11-12.
Step 3:
Install new filters (purchase the correct
evaporative wicking filter pads HDC12 for
your humidifier) into the location where
the old filters were positioned. Install the
filter housings with the new filters into the
correct location.
Reinstall the w
ater level
float.
NOTE: Float retainer should be
positioned in normal operating mode.
Assure that it is positioned in the bottom
of the slot in the back of the cabinet (See
page 9 for diagram of slot).
Position the fan assemb
ly on top of the
cabinet and retur
n the humidifier to the
desired location for use.
Removing Scale
1. Fill the reservoir with water and
add one 8 oz. (236 ml) cup of
undiluted white vinegar. Let solution
stay for 20 minutes.
2. Clean all interior surfaces with soft
brush. Dampen soft cloth with
undiluted white vinegar and wipe
out reservoir to remove scale.
3. Rinse thoroughly with clean warm
water to remove scale and cleaning
solution before disinfecting the
reservoir.
Disinfecting Humidifier
Cabinet and Water Bottles
1. Fill humidifier cabinet with
1 teaspoon (5 ml) chlorine bleach
in 1 gallon (3.8 litres) of water.
Let solution stay for 20 minutes,
carefully swishing every few
minutes. Wet all surfaces normally
exposed to water.
2. Empty humidifier cabinet after 20
minutes. Rinse with water until
bleach smell is gone. Allow unit to
dry out completely.
3. Water bottles should be cleaned in
the same manner.
Bi-Weekly Maintenance
End of Season Maintenance
1. Follow “Bi-Weekly Maintenance”
instructions at end of humidification
season.
2. Remove and throw away filters.
3. Let humidifier dry completely before
storing. Do not store with water inside
cabinet or water bottles.
4. Store in cool, dry location.
5.
Install a ne
w filters in clean humidifier
before next season begins.
6. “Bi-Weekly Maintenance” procedure is
also recommended if y
ou do not plan
to run the humidifier for one week or
more.
WARNING: To reduce the risk of shock,
always unplug humidifier before cleaning
or servicing. If humidifier is not unplugged,
fan could start after housing is removed.
Refill humidifier bottles with fresh cool
water and return them to the cabinet.
Plug the unit into a 120 volt A.C. power
outlet and set the controls per the
“Operating Humidifier Controls” section
(page 8) of this manual.
SP6647.qxd 7/5/06 8:23 AM Page 13
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels